![]() John’s Hub considers the piece above a failed piece. ![]() The piece above has been printed and is still sitting on the glass plate that supports it during printing.Ībove, the support piece under keys C and D has been removed. A good 3D print shop will know how to do this: The overall keyboard works and is acceptable to me.Ĥ.) The keyboard files should be printed with a support under keys C and D. If you look at the picture at the top of the page, you can see the keys C and D are a bit deformed on the left, but not on the right. Minor faults can be bent back into place after softening the material with a heat gun. John’s Hub does this for me and does not charge extra for it.ģ.) 3D printing melts the plastic and then lets it set to re-harden. If you Google PLA and acetone, you will come up with multiple videos describing how to use acetone to improve a 3D printed figure. They can be removed with sand paper or acetone (which slightly dissolves the plastic). ![]() These pieces take multiple hours to print and tie up an expensive piece of machinery, so that determines the price.Ģ.) Surface imperfections will happen. Printing with a resolution of 0.1 mm will give a nicer model, but printing will take at least twice as long and will cost you twice as much. He has given me these tips on printing the files.ġ.) Printing was done with PLA plastic, a low cost material used for printing prototypes. The printing process is not always flawless. My 3D keyboards were printed by John’s Hub of 3D Hubs website. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |